Ivan Labs El Sid SID10PV DC Circulating
Pump (2W2RD31730)
Ivan Labs Inc. El Sid SID10PV
is a 10 watt 12 volt PV (solar module)
direct pump capable of circulating up
to 3.3 gallons per minute of water. It
operates directly from a solar module with an
input voltage up to 20 volts. The
SID10PV starts to operate at 8 volts with
as little power as 1 watt. This pump is
designed to be used with a 10 watt module
for circulating water and 20 watt module
for glycol. It can be wired direct to the
module in a solar hot water system eliminating
the need for controls. When the sun shines
the SID10PV turns on circulating water or
glycol through a hot water collector. When the
sun goes down the pump turns off. It's that
simple!
You may also use a 2W2DELTA/12
temperature controller for more accurate and
efficient operation.
The SID10PV is large enough
to circulate water in a system with up to
three 4X10 foot collectors using a 10
watt module. It can circulate glycol in a
system with up to two 4X10 foot
collectors using a 20 watt
module.
For a water system with more
than three collectors or a volume more
than 3.3 gallons per minute a larger pump
or multiple pumps are required. For a glycol
system with more than two collectors or a
volume more than 3.3 gallons per minute, a
larger pump or more than one pump is
required.
Like all PV direct El Sid pumps its
features are as follows:
- Operates with
direct current eliminating the need for an
inverter
- Can accept
voltage from 0 to 20 volts eliminating the
need for a battery
- Brushless
- Maintenance
free
- No bearings to
wear out or overheat
- Very quiet for
use in any area of a
home
- Can operate in
temperatures up to
250oF
- High pressure
(up to 175 psi)
- Locked impeller
protected for PV
applications
- Very small and
light weight (2.75" sq , 2
lbs)
- Can be mounted
on vertical or horizontal
piping
Specifications:
| Watts |
10
|
| Maximum Head in Feet |
3.5 |
| Maximum Flow in GPM |
3.3 |
| Operating Voltage
(DC) |
8 to 20 |
|
